What You Will Need:
Torx T8
Soldering Iron + Solder
Tweezers (optional)
0603 LEDS
Time
Wipe (to clean the solder)
Step 1: Tape all the A X Y and the Start/Back + Guide Ring down to the controller so they don't fall off. Unscrew all the screws of the back of the controller.
Step 2: Take the case off and remove the board, + the thumbsticks and rubber inside.
Step 3: Remove these 4 leds using your solder. [To solder it out, place solder on the soldering iron, and simply tap around the edges of the leds. Remove the LEDS carefully if you wish to reuse them]
Step 5
lace the new LED's positive side to the bolded white and solder it in place.
Step 6: Test if it works by placing it on the back piece of the controller shell, and place the rubber in place. Also, place the battery in place, and turn it on, and check if it works.
[video=youtube]http://www.youtube.com/watch?v=BnAUToSHjAM[/video][/CENTER]
Torx T8
Soldering Iron + Solder
Tweezers (optional)
0603 LEDS
Time
Wipe (to clean the solder)
Step 1: Tape all the A X Y and the Start/Back + Guide Ring down to the controller so they don't fall off. Unscrew all the screws of the back of the controller.
Step 2: Take the case off and remove the board, + the thumbsticks and rubber inside.
Step 3: Remove these 4 leds using your solder. [To solder it out, place solder on the soldering iron, and simply tap around the edges of the leds. Remove the LEDS carefully if you wish to reuse them]
Step 5
lace the new LED's positive side to the bolded white and solder it in place.Step 6: Test if it works by placing it on the back piece of the controller shell, and place the rubber in place. Also, place the battery in place, and turn it on, and check if it works.
[video=youtube]http://www.youtube.com/watch?v=BnAUToSHjAM[/video][/CENTER]
